Cart  

No products

0.00 € Total products

Check out

CYPRES 2 - Expert View full size

CYPRES 2 - Expert

AAD for individual reserve rig

More details

1,145.00 €

(954.17 € tax excl.)

Availability: Available within 6 weeks

6 other products in the same category:

Tested Reliability and Performance!

Resulting from the experiment of Airtec with Cypres 1, CYPRES 2 guarantees effectiveness and reliability to you. What one waits precisely and without exception of its safety appliance ! 

The EXPERT CYPRES 2 can be recognized by the red button on the control unit.

It activates the release unit when it detects a rate of descent higher than 78 mph (35 m/sec) at an altitude of approx. 750 feet (approx. 225 meters) above ground level (AGL).
In the event of a cutaway below this height CYPRES will operate down to approx. 130 feet AGL, however activation will not occur unless sufficient speed is obtained.
Below approx. 130 feet (approx. 40 meters) AGL opening is no longer useful.
For this reason, CYPRES ceases operation below approximately 130 feet AGL.

Water resistant: up to 15 minutes at depth of 15 feet

Technical Data :
      Weight : approx. 182 grams
      Activation altitude : approx.750 feet (225 m)
      Activation speed : approx. ³ 78 mph (35 m/s)
      Length, width, height of the processing unit : approx. 85 x 43 x 32 mm
      Length, width, height of the control unit : approx. 65 x 18 x 6,5 mm
      Length, diameter of the release unit : approx. 43 x 8 mm

      Altitude adjustment limits: ±1500 feet or ±500 m
      Operating range below / above sea level: -1500 feet to +26,000 feet (-500 m to +8000 m)
      Functioning period: 14 hours from switch-on

 

NEW 

 

LIFETIME
CYPRES2's lifetime is now 15 years 6 monts for units manufactured until 01/01/2017 !
Lifetime is 12 years 6 months for units manufactured before 01/01/2017.

MAINTENANCE
Maintenance is recommended every 5 years for units manufactured after 01/01/2017.
It's recommended every 4 years for units manufactured before 01/01/2017.
Maintenance included :

  • Battery's change
  • Tests in hot and cold chamber
  • Verification of all elements - change if necessary
  • New software downloaded 

 

TRADE PROGRAM
AIRTEC gives a 60 € discount if you give back your old CYPRES with valid cutter. Contact us for more informations.


Available Models1 or 2 pins 

No customer comments for the moment.

Write your review

CYPRES 2 - Expert

CYPRES 2 - Expert

AAD for individual reserve rig

Write your review