Cart  

No products

0.00 € Total products

Check out

CYPRES 2 - Student View full size

CYPRES 2 - Student

AAD for Student canopy

More details

1,145.00 €

(954.17 € tax excl.)

Availability: Available within 2 weeks

5 other products in the same category:

Tested Reliability and Performance!

Resulting from the experiment of Airtec with Cypres 1, CYPRES 2 guarantees effectiveness and reliability to you. What one waits precisely and without exception of its safety appliance ! 

The STUDENT CYPRES 2 can be recognized by the yellow button with the imprint "Student"on the control unit.

It will activate the release unit when the rate of descent exceeds 29 mph (13 meters per second). The activation altitude is split. In the case of rate of descent being equal to that of freefall, the opening altitude is at approx. 750 feet (the same as with Expert CYPRES). However, should the rate of descent be lower than that of freefall but still above the limit of 29 mph (e.g. with partially opened canopy, or after a cutaway), then Student CYPRES activates the release unit when the altitude falls below approx. 1000 feet (approx. 300 meters) above ground level. The student will then have more time to prepare for landing. Like the Expert CYPRES, the Student CYPRES ceases operation below approx. 130 feet AGL.
Unlike the Expert and Tandem CYPRES models, we recommend that the Student CYPRES be switched off in the aircraft prior to descent if the jump is aborted and the student will land with the plane, because the vertical speed of a descending jump plane will exceed the activation speed of Student CYPRES.

Be aware that it is possible to exceed a vertical speed of 29 mph (13 meters per second) under a fully inflated canopy !

If a jump plane is descending with students still on board, switch the Student CYPRES off before reaching 1500 ft (450 meters) above ground.
If this is not possible, the descent rate of the plane must not exceed 1500 ft/min below 1500 feet above ground. Close open doors.

Water resistant: up to 15 minutes at depth of 15 feet

Technical Data :
      Weight : approx. 199 grams
      Length, width, height of the processing unit : approx. 85 x 43 x 32 mm
      Length, width, height of the control unit : approx. 65 x 18 x 6,5 mm
      Length, diameter of the release unit : approx. 43 x 8 mm

      Altitude adjustment limits: ±1500 feet or ±500 m
      Operating range below / above sea level: -1500 feet to +26,000 feet (-500 m to +8000 m)
      Functioning period: 14 hours from switch-on

NEW 

LIFETIME
CYPRES2's lifetime is now 15 years 6 monts for units manufactured until 01/01/2017 !
Lifetime is 12 years 6 months for units manufactured before 01/01/2017.

MAINTENANCE
Maintenance is recommended every 5 years for units manufactured after 01/01/2017. 
It's recommended every 4 years for units manufactured before 01/01/2017.

Maintenance included :

•Battery's change

•Tests in hot and cold chamber

•Verification of all elements - change if necessary

•New software downloaded 

TRADE PROGRAM
AIRTEC gives a 60 € discount if you give back your old CYPRES with valid cutter. Contact us for more informations.

Available Models1 or 2 pins 

No customer comments for the moment.

Write your review

CYPRES 2 - Student

CYPRES 2 - Student

AAD for Student canopy

Write your review