Cart  

No products

0.00 € Total products

Check out

CYPRES 2 - WSC View full size

CYPRES 2 - WSC

AAD for reserve rig - Wingsuit mode

More details

1,530.00 €

(1,275.00 € tax excl.)

Availability: Available within 8 weeks

8 other products in the same category:

Virtually all AADs designed for skydiving have one parameter combination to define their activation. A certain height and a certain vertical speed make them activate. That has served the needs since the beginning of skydiving. Until Wing Suits appeared. They allow such slow vertical speed that the method of the last 90 years cannot deal with these conditions any more. A new solution was necessary.

The use of Wing Suits requires not one, but two parameter combinations during the same jump. One is needed for the duration of the Wing Suit Flight and another one is needed for the duration of the Canopy Flight.

The WSC starts off by using the Wing Suit parameters, which covers specific Wing Suit flight risks. Once it detects the criteria of your canopy, it changes the Wing Suit parameters to the canopy parameters and informs you about the change.

HOW IT WORKS ?

Aside from Wingsuiting, the WSC can also be used for all other disciplines too. Also, the handling is identical to all other civilian CYPRES models, except placing the Audio inside your helmet and listening to the melodic sound. Nevertheless, we ask everybody using this device to spend time to inform themselves about the physical circumstances of Wingsuit Flying and the technique behind the WSC.

HOW IT WORKSwsc-principle-scetch-02e

The WSC starts off by using the wingsuit parameters, which covers the specific wingsuit flight risks. While you are descending, it continuously monitors your maneuvers, and once it detects the criteria of your canopy, it changes the wing suit parameters to the canopy parameters. These will take care of your specific canopy flight risks.
 For the canopy flight, you can set your WSC to be an Expert or a Speed CYPRES, just as you need. Once you have set it, it will last until you reset it.
 As soon as your WSC has switched to the parameters of the canopy flight, it will let you know. You will hear a melodic sound for some seconds via the WSC Audio. That is important, even mandatory because only the confirmation assures that you now can do all the extreme manoeuvres that your canopy allows you.

Wing Suit Status:  
Activation altitude Wing Suit Status: approx. 750 – 130 feet
Activation speed Wing Suit Status: approx. > 45 mph (20 m/s)
Canopy Status:  
Activation altitude Canopy Status: according to set MODE
Activation speed Canopy Status: according to set MODE
Status Change:  
between approx. 6500 feet (2000 meters) and
approx. 1500 feet (450 meters) above ground
when descending less than approx. 19 mph (8,5 m/s), but more
than approx. 5.6 mph (2.5 m/s)
for 6-20 seconds depending on where this
status change time is programmed
Default status change time 10 seconds
Volume: approx. 139 cm³
Weight: approx. 198 grams
Length, width, height of the processing unit: approx. 85 x 43 x 32 mm
Length, width, height of the control unit: approx. 65 x 18 x 6.5 mm
Cable length of control unit: approx. 650 mm
Length, diameter of the release unit: approx. 43 x 8 mm
Cable length of the release unit (including release unit): approx. 500 mm
Storage temperature: +71° to -25° Celsius
Storage pressure: 200 to 1094 hPa ( 5.906 to 32.306 In.Hg)
Working temperature: +63° to -20° Celsius*
Maximum allowable humidity: up to 99.9 % rel. humidity
Waterproof: up to 24 hours down to a depth of 8 feet (2.5 meters)
Dropzone offset adjustment limits: ±1050 feet or ±350 m
Operating range below / above sea level: -2140 feet to +26,000 feet (-650 m to +8000 m)
Functioning period: 14 hours from switch-on
Power supply: service life warranty**
Maintenance: For units with DOM 01/17 and later the maintenance is recommended to be performed 5 and 10 years after the original DOM.***
Warranty Period: see Airtec warranty policy
Service life: DOM later 01.01.2017: 15.5 years from date of manufacture

*These temperature limits do not mean the outside (ambient) temperatures but rather temperatures inside the processing unit. Therefore, these limits won‘t have any meaning until the processing unit itself has reached the temperatures in question. In actual fact, these limits will rarely be reached due to the location of the CYPRES in the reserve container, and the insulating properties of the processing unit pouch and parachute canopies.

 

** If recommended maintenances have been performed within the scheduled time frames.

*** According to the present knowledge base.


NEW 

LIFETIME
CYPRES2's lifetime is now 15 years 6 monts for units manufactured until 01/01/2017 !
Lifetime is 12 years 6 months for units manufactured before 01/01/2017.

MAINTENANCE
Maintenance is recommended every 5 years for units manufactured after 01/01/2017. 
It's recommended every 4 years for units manufactured before 01/01/2017.

Maintenance included :

•Battery's change

•Tests in hot and cold chamber

•Verification of all elements - change if necessary

•New software downloaded 

 

TRADE PROGRAM

AIRTEC gives a 60 € discount if you give back your old CYPRES with valid cutter. Contact us for more informations.

No customer comments for the moment.

Write your review

CYPRES 2 - WSC

CYPRES 2 - WSC

AAD for reserve rig - Wingsuit mode

Write your review